DMACC Diesel Technology Required Tool List

REV: 10/01

1. Tool Box (suitable to hold the following tools, a roller box is suggested)

2. ½” Drive socket/ratchet set

breaker bar

extensions

3/8” –1” standard sockets

12 – 24 mm metric sockets

3. 3/8” Drive socket/ratchet set

breaker bar

extensions

3/8” – ¾” standard sockets

6 – 19 mm metric sockets

Torx bits 3/8” drive sockets

4. Wrenches

3/8” – 1” combination

6 – 22 mm metric combination

3/8” – 3/4” line wrenches

5. Standard screwdriver set

6. Phillips screwdriver set

7. Chisel and punch set

8. Pry Bars

20” rolling head pry bar

24” straight pry bar

9. Pliers

7 1/8” needle nose

         9 1/4” channel lock type

         7 1/4” diagonal cut

         10” vise grip

         Combination crimper/wire strippers

         Piston ring installers

         Locking ring – opens to 1 ¼” min.

10. Hammers

         16 oz. Ball peen

         32 oz. Ball peen

         2 or 2 ½ lb. Hammer

         24oz. Dead blow hammer

11. Allen wrench set (L type) 1/16” – 3/8”

12. Feeler gauges (.0015” - .035”)

         Straight

         Bent

13. Gasket scraper (heavy duty)

14. 6” steel ruler

15. 12’ steel tape measure

16. Hacksaw with the following blades 4-18 TPI and 4-24 TPI

17. Flat hand file with handle 10” mill

18. Flashlight with batteries

19. Oil filter wrench (should fit both small and large filters)

20. Pick-up magnet

21. Brake tools

 brake adjusting tool 8”

 brake retainer washer tool (small/large)

 brake spring pliers, remove and replace

22. ½” drive torque wrench 0-200 ft/lb min.

23. Digital multi meter

         read Volts – milli Amps – Ohms

         Minimum 10 Mega Ohms impedance

         With Auto Range

24. Volt test light (non powered)

25. OSHA approved blow gun with ¼” NPT male plug

26. Safety glasses or Safety goggles