DMACC Diesel Technology Required Tool List
REV: 10/01
24. Tool Box (suitable to hold the following tools, a roller box is suggested)
2. ½ Drive socket/ratchet set
breaker bar
extensions
3/8 1 standard sockets
12 24 mm metric sockets
3. 3/8 Drive socket/ratchet set
breaker bar
extensions
3/8 Ύ standard sockets
6 19 mm metric sockets
Torx bits 3/8 drive sockets
4. Wrenches
3/8 1 combination
6 22 mm metric combination
3/8 3/4 line wrenches
5. Standard screwdriver set
6. Phillips screwdriver set
7. Chisel and punch set
8. Pry Bars
20 rolling head pry bar
24 straight pry bar
9. Pliers
7 1/8 needle nose
9 1/4 channel lock type
7 1/4 diagonal cut
10 vise grip
Combination crimper/wire strippers
Piston ring installers
Locking ring opens to 1 Ό min.
10. Hammers
16 oz. Ball peen
32 oz. Ball peen
2 or 2 ½ lb. Hammer
24oz. Dead blow hammer
11. Allen wrench set (L type) 1/16 3/8
12. Feeler gauges (.0015 - .035)
Straight
Bent
24. Gasket scraper (heavy duty)
25. 6 steel ruler
26. 12 steel tape measure
27. Hacksaw with the following blades 4-18 TPI and 4-24 TPI
28. Flat hand file with handle 10 mill
29. Flashlight with batteries
30. Oil filter wrench (should fit both small and large filters)
31. Pick-up magnet
32. Brake tools
brake adjusting tool 8
brake retainer washer tool (small/large)
brake spring pliers, remove and replace
33. ½ drive torque wrench 0-200 ft/lb min.
23. Digital multi meter
read Volts milli Amps Ohms
Minimum 10 Mega Ohms impedance
With Auto Range
24. volt test light (non powered)
25. OSHA approved blow gun with Ό NPT male plug
26. Safety glasses or Safety goggles